NCKrawlers :: Forums :: NCK Tech Forums :: General Tech
<< Previous thread | Next thread >>
Hey Crusty.....
Moderators: Administrator, NC-Fordguy, KrawlinYJ
Author Post
Wed Feb 09 2011, 09:38PM

Registered Member #2
Joined: Tue Mar 06 2007, 05:53PM
Location: Bethel NC
Posts: 1153
These are the axle shafts for a 44 I was telling you about.

From what I have read they get a 44 to the strength of a stock 60

Guys on the bronco board are running them with 40in tires, stroked v-8s, lockers etc and the axle shafts are holding up from what I have read.

Extemely pricey though

No Hablos Jeep

If it doesn't make sense, do it
Back to top
Mr. Gray
Wed Feb 09 2011, 10:37PM
NCK Member
Registered Member #339
Joined: Sat Jan 15 2011, 02:42PM
Location: Jacksonville NC
Posts: 127
Thanks for the link!

They are high dollar for sure.

You going to try em?

And nice meeting again.

03 S10 D44 Front, GM 10bolt Rear, 4.88 gears sittin on 36's
Back to top

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System