Forums
NCKrawlers :: Forums :: We Done Did It :: Past Trail Reports
 
<< Previous thread | Next thread >>
Uwharrie Dec. 4th
Go to page   <<        >>  
Moderators: Administrator, NC-Fordguy, KrawlinYJ
Author Post
CDTXJ97
Mon Nov 22 2010, 08:58PM
NCK Member
Registered Member #278
Joined: Wed Mar 10 2010, 10:09PM
Location: Farmville
Posts: 261
give me a call if you need a hand

97 XJ in pieces..
Back to top
Kinlaw
Mon Nov 22 2010, 09:54PM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
Are you ready cory?

XJ on 33's with some extra steel here and there

Back to top
CDTXJ97
Mon Nov 22 2010, 09:58PM
NCK Member
Registered Member #278
Joined: Wed Mar 10 2010, 10:09PM
Location: Farmville
Posts: 261
work on it..i hope to do breaks on the rear axle tmr still gotta do front break line rotor and pads few other small things that wont take no time biggest thing now is the axle

97 XJ in pieces..
Back to top
CDTXJ97
Mon Nov 22 2010, 09:59PM
NCK Member
Registered Member #278
Joined: Wed Mar 10 2010, 10:09PM
Location: Farmville
Posts: 261
and plating tow points (i plan on useing them this trip)

97 XJ in pieces..
Back to top
toyzilla
Tue Nov 23 2010, 08:34AM
Moderater

Registered Member #12
Joined: Mon Mar 12 2007, 10:39AM
Location: Tarboro, NC
Posts: 477
Kinlaw wrote ...

Alright it looks like it is just going to be the five of us if Cory and Redman gets there stuff together.

I got the brakes finished and hooked up the emergency Brake ( As stated in the NC KRAWLERS VEHICLE REQUIREMENTS) on the D44 rear. I ran into a little problem with the rear shocks. After relocating the lower rear shock mounts I only have about 2" of up travel. I think that I am going to have to cut holes in the rear cargo area and slip them through the floor to a custom shock hoop. I'm not really sure what would work the best. I could probably run stock shocks but would loss axle down travel. Hoping to get it done over Thanksgiving.


I only have 3" of up travel. and works great.


"take it to the eXtreme"

93 Toyota Custom Built Tube Buggy Rock Crawler
4-link F&R, 36" TSL tires, 12k winch, Fox Shox, lock & loaded, dual cases, beadlocks , New Dirty 30 Front Axles
Check Out My Rig and Trail Rides. My photo's
scimpressions.com
Back to top
toyzilla
Tue Nov 23 2010, 08:37AM
Moderater

Registered Member #12
Joined: Mon Mar 12 2007, 10:39AM
Location: Tarboro, NC
Posts: 477
Ed going to bring me the tent and ready welder for the trip.

my rigs ready.

"take it to the eXtreme"

93 Toyota Custom Built Tube Buggy Rock Crawler
4-link F&R, 36" TSL tires, 12k winch, Fox Shox, lock & loaded, dual cases, beadlocks , New Dirty 30 Front Axles
Check Out My Rig and Trail Rides. My photo's
scimpressions.com
Back to top
Kinlaw
Tue Nov 23 2010, 10:14AM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
toyzilla wrote ...

I only have 3" of up travel. and works great.



With the set up I have most of my suspension travel is up unlike yours. Without the shocks attached I am getting around 6" or 7" inches of up travel. I think that it's time to break out the hole saw. And you know that I am always looking for a reason to cut up the Jeep.

It really sucks that SAYWHENCJ and Greg are not going to make it. Was looking forward to having a bigger group.

XJ on 33's with some extra steel here and there

Back to top
Kinlaw
Tue Nov 23 2010, 10:16AM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
Did you guys want to go out to eat on Saturday in Troy or did you want to cook at camp. I really don't care just trying to figure out what to bring.

XJ on 33's with some extra steel here and there

Back to top
toyzilla
Tue Nov 23 2010, 04:25PM
Moderater

Registered Member #12
Joined: Mon Mar 12 2007, 10:39AM
Location: Tarboro, NC
Posts: 477
i Think we should go out to eat sat night, it be cold out, . we all headed there friday?
post time of leaving so maybe we could convey


"take it to the eXtreme"

93 Toyota Custom Built Tube Buggy Rock Crawler
4-link F&R, 36" TSL tires, 12k winch, Fox Shox, lock & loaded, dual cases, beadlocks , New Dirty 30 Front Axles
Check Out My Rig and Trail Rides. My photo's
scimpressions.com
Back to top
Kinlaw
Tue Nov 23 2010, 04:35PM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
I want to leave early and get some riding time on Friday. It might be nice to warm up and eat some hot food in Troy.

Leaving Time
Friday between 8:00a.m. and 9:00a.m.

XJ on 33's with some extra steel here and there

Back to top
CDTXJ97
Tue Nov 23 2010, 05:45PM
NCK Member
Registered Member #278
Joined: Wed Mar 10 2010, 10:09PM
Location: Farmville
Posts: 261
ill be leaving around 12 i gotta work they would give me the day off i need some help with drum breaks if any one could give me a hand i think i have everything else covered


97 XJ in pieces..
Back to top
redman
Tue Nov 23 2010, 08:26PM
NCK Officer

Registered Member #15
Joined: Mon Mar 12 2007, 06:47PM
Location: Colerain, NC
Posts: 260
well still working on my jeep got alot of stuff for it water lines are done just got to get it back together now


big mean machine - D44 front 12 bolt rear, stuffed with 4.88 gears, locked front and rear, all powered by a 360 on propane

Back to top
Kinlaw
Tue Nov 23 2010, 08:47PM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
Alright I can't wait!

XJ on 33's with some extra steel here and there

Back to top
redman
Wed Nov 24 2010, 07:06PM
NCK Officer

Registered Member #15
Joined: Mon Mar 12 2007, 06:47PM
Location: Colerain, NC
Posts: 260
i need one open seat some one any one got a open seat

big mean machine - D44 front 12 bolt rear, stuffed with 4.88 gears, locked front and rear, all powered by a 360 on propane

Back to top
Kinlaw
Fri Nov 26 2010, 05:51PM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
Remounted upper shock mounts and add temporary transfer-case skid. The jeep is ready, all I got to do is air down and load up.

XJ on 33's with some extra steel here and there

Back to top
Kinlaw
Sun Nov 28 2010, 03:30PM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
Cory just texted me and is out.


XJ on 33's with some extra steel here and there

Back to top
toyzilla
Sun Nov 28 2010, 04:32PM
Moderater

Registered Member #12
Joined: Mon Mar 12 2007, 10:39AM
Location: Tarboro, NC
Posts: 477
Kinlaw wrote ...

Cory just texted me and is out.


Do what?? no drop outs ...


I have fire wood.
and got my elec blanket 2day.
ready to go

"take it to the eXtreme"

93 Toyota Custom Built Tube Buggy Rock Crawler
4-link F&R, 36" TSL tires, 12k winch, Fox Shox, lock & loaded, dual cases, beadlocks , New Dirty 30 Front Axles
Check Out My Rig and Trail Rides. My photo's
scimpressions.com
Back to top
CDTXJ97
Sun Nov 28 2010, 05:47PM
NCK Member
Registered Member #278
Joined: Wed Mar 10 2010, 10:09PM
Location: Farmville
Posts: 261
ima still go im sure i just not goin to be 100% i dont think the 35 and ledges will get along to good..im going for sure just might have to sit out on a few things

97 XJ in pieces..
Back to top
Kinlaw
Sun Nov 28 2010, 05:59PM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
Come on Cory the 35 is fine.

Toyzilla do I need to bring any more fire wood or do you have enough?

I just changed the oil in the F-250, put on the camper shell, check all the fluids in the XJ, and started loading the jeep.

I can't wait to go.

XJ on 33's with some extra steel here and there

Back to top
redman
Sun Nov 28 2010, 06:05PM
NCK Officer

Registered Member #15
Joined: Mon Mar 12 2007, 06:47PM
Location: Colerain, NC
Posts: 260
Any one off tommorw that can help me out give me a call 287-8300

big mean machine - D44 front 12 bolt rear, stuffed with 4.88 gears, locked front and rear, all powered by a 360 on propane

Back to top
redman
Mon Nov 29 2010, 05:04PM
NCK Officer

Registered Member #15
Joined: Mon Mar 12 2007, 06:47PM
Location: Colerain, NC
Posts: 260
Well the big jeep is out so I'm bring the 48

big mean machine - D44 front 12 bolt rear, stuffed with 4.88 gears, locked front and rear, all powered by a 360 on propane

Back to top
Kinlaw
Mon Nov 29 2010, 06:15PM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
I have been looking around the net to see if there are going to be alot of rigs out this weekend, it looks like the Triad Trail Junkies, a large group of Tocomas, NC Land Cruiser club, and maybe Lost 4X4. Should see alot of rigs.

XJ on 33's with some extra steel here and there

Back to top
redman
Mon Nov 29 2010, 06:27PM
NCK Officer

Registered Member #15
Joined: Mon Mar 12 2007, 06:47PM
Location: Colerain, NC
Posts: 260
Kinlaw call me

big mean machine - D44 front 12 bolt rear, stuffed with 4.88 gears, locked front and rear, all powered by a 360 on propane

Back to top
Kinlaw
Mon Nov 29 2010, 08:07PM
NCK Member

Registered Member #294
Joined: Thu Jul 15 2010, 07:19AM
Posts: 154
Send me a pm with your phone #

XJ on 33's with some extra steel here and there

Back to top
toyzilla
Tue Nov 30 2010, 08:40AM
Moderater

Registered Member #12
Joined: Mon Mar 12 2007, 10:39AM
Location: Tarboro, NC
Posts: 477
Kinlaw wrote ...

Come on Cory the 35 is fine.

Toyzilla do I need to bring any more fire wood or do you have enough?

I just changed the oil in the F-250, put on the camper shell, check all the fluids in the XJ, and started loading the jeep.

I can't wait to go.

ya you could bring some more fire wood,



"take it to the eXtreme"

93 Toyota Custom Built Tube Buggy Rock Crawler
4-link F&R, 36" TSL tires, 12k winch, Fox Shox, lock & loaded, dual cases, beadlocks , New Dirty 30 Front Axles
Check Out My Rig and Trail Rides. My photo's
scimpressions.com
Back to top
Go to page   <<        >>   

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System