NCKrawlers :: Forums :: NCK Tech Forums :: General Tech
<< Previous thread | Next thread >>
tranferr case
Moderators: Administrator, NC-Fordguy, KrawlinYJ
Author Post
Sun Aug 16 2009, 09:18PM

Registered Member #253
Joined: Sun Jul 26 2009, 03:21PM
Location: near myrtle beach sc
Posts: 19
89 cj 7 my lo-range kicks out, i have to tie it back to keep it locked in, but even at that it does not turn the front wheels, when i lock the wheels. I can see the drive shaft turn, the front ssems to lock in, in high range, any ideas out there

[ Edited Sun Aug 16 2009, 09:22PM ]

Back to top
Sun Aug 16 2009, 09:41PM

Registered Member #2
Joined: Tue Mar 06 2007, 05:53PM
Location: Bethel NC
Posts: 1153
Perhaps some of the jeep guys can chime in here.....

My experience is with early broncos. If you have a dana series t-case I'd check to see if the shifter(s) are adjusted accordingly

Provided you do have a dana series case sounds like worn or broken detent springs on the shift rails

No Hablos Jeep

If it doesn't make sense, do it
Back to top
Mon Aug 17 2009, 05:45AM
Registered Member #23
Joined: Sun Mar 18 2007, 10:12PM
Posts: 543
no such thing as a 1989 cj-7 Larry.Need to clarify what you have.
Back to top
Mon Aug 17 2009, 01:04PM

Registered Member #21
Joined: Tue Mar 13 2007, 05:17PM
Location: Greenville, NC
Posts: 703
Bearing pre-load can affect what you are describing. But we really need to know what vehicle you have.

1989 had the YJ (square headlights) and the NP231? transfercase?

If its a CJ7, the newest will be a 1986.
Back to top

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System