Forums
NCKrawlers :: Forums :: Classifieds :: For Sale
 
<< Previous thread | Next thread >>
TJ dash cage support
Moderators: Administrator, NC-Fordguy, KrawlinYJ
Author Post
rockcity
Tue Mar 10 2009, 01:54PM

Registered Member #21
Joined: Tue Mar 13 2007, 05:17PM
Location: Greenville, NC
Posts: 703
These are for the A pillar of the TJ cage cages. It is laser cut from 1/4" thick plate and made to fit betwen the dash and hard doors. This way you don't have to cut up your dash for a TJ cage.

These are a few years old and have some surface rust on them, but otherwise are new. These were prototypes I had cut for someone's TJ but they sold the TJ before these were installed. The only problem with them is the top bolt hole that attaches to the factory bolt holes is about 1" too low. I guess when I drew it up I put the slot on the wrong side of my mark and slotted it down instead of up. Oh well, a backing plate, some weld and a buffing pad will fix it really quick. It uses factory bolt holes, etc. I also have some baseplates for mounting to the floorboard.

I can get pics up within the next day or so.

If anyone saw John's TJ cage (jeepercreature), those are the same identical ones as here. I can't find the pics of them.

$100 for the pair. Located in Greenville, NC

[ Edited Tue Mar 10 2009, 02:01PM ]

www.ECORS.com
Back to top
 

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System