Forums
NCKrawlers :: Forums :: NCK Tech Forums :: Pimp my 4x4
 
<< Previous thread | Next thread >>
my junk
Go to page   <<      
Moderators: Administrator, NC-Fordguy, KrawlinYJ
Author Post
RenegadeCJ
Sat Mar 28 2009, 01:02PM
Moderator

Registered Member #7
Joined: Thu Mar 08 2007, 09:40PM
Location: Belhaven, NC (boondocks)
Posts: 174
update springs arrived yesterday. stuff from ruff stuff will be here on monday i think. so will probabbly be doing the front end next weekend. then i should be back rolling on a almost new drivetrain.

also my fuel pressure regulator came in, oil pressure shut off switch, have to wire these into the system as well.

79 cj-5
in the procces of being rebuilt
Back to top
RenegadeCJ
Tue Apr 28 2009, 12:10PM
Moderator

Registered Member #7
Joined: Thu Mar 08 2007, 09:40PM
Location: Belhaven, NC (boondocks)
Posts: 174
been consumed with spring yard work. but on a positive note got the shackle reversal system from BTF welded in place and winch plate mounted to front bumper. will be installing the front axle in the evenings this week i hope. might have to cut and reweld the perches on the rear (pinion angle was set while on stands damn i screwed that one up). but is no big deal

79 cj-5
in the procces of being rebuilt
Back to top
RenegadeCJ
Sun May 03 2009, 08:45PM
Moderator

Registered Member #7
Joined: Thu Mar 08 2007, 09:40PM
Location: Belhaven, NC (boondocks)
Posts: 174
front bumper/shakle reversal unit from blue torch fab installed. axle under rig. have to figure out shock mounts for front hook up brake lines, and have the steering link shortend. also need a stock pitman arm from a cj style steering box if anyone has one

79 cj-5
in the procces of being rebuilt
Back to top
RenegadeCJ
Thu Jul 23 2009, 11:01AM
Moderator

Registered Member #7
Joined: Thu Mar 08 2007, 09:40PM
Location: Belhaven, NC (boondocks)
Posts: 174
small update got to work on jeep last friday for a little while.

got the MORE steering box relocation bracket mounted, the cross frame steering box braket mounted, all the lock nuts installed on springs and shackles. got drag link measured just need to order the weld in bungs to shorten it.

79 cj-5
in the procces of being rebuilt
Back to top
rockcity
Mon Jul 27 2009, 12:19PM

Registered Member #21
Joined: Tue Mar 13 2007, 05:17PM
Location: Greenville, NC
Posts: 703
what size tube adapters do you need? I have some extras laying around

www.ECORS.com
Back to top
RenegadeCJ
Mon Jul 27 2009, 03:09PM
Moderator

Registered Member #7
Joined: Thu Mar 08 2007, 09:40PM
Location: Belhaven, NC (boondocks)
Posts: 174
ill be back at my house on sunday i think ill look and give you a call rob thanks

79 cj-5
in the procces of being rebuilt
Back to top
Go to page   <<       

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System